pasobgourmet.blogg.se - Globaltis ecu file location

GLOBALTIS ECU FILE LOCATION INSTALL
GLOBALTIS ECU FILE LOCATION SERIAL
GLOBALTIS ECU FILE LOCATION SOFTWARE

This displays an Information window (Figure 1.15).ĩ Follow the instructions on the Information window and then click the OK button. The installation of the USB security key requires strict attention or TIS2000 will not perform as expected.Ĩ Click the checkbox above USB Security Key to place a checkmark in the box (Figure 1.14). Note: The Security Device Installation module configures the USB security key, which is a component of the SPS Kit. Note: This installation of TIS2000 supports reflash of TIS2000 Security Device Add / Remove window. This configures settings, starts theĭecurity Device Installation module, and displays the This displays the Set DEALERSHIP window.ħ Select NAO (North American Operations) and thenĬlick the Next button. This displays the TIS2000 Installation Mode window.Ħ Select Standalone and then click the Next button. This must be an open COM port where no external devices are connected.

GLOBALTIS ECU FILE LOCATION SERIAL

Optionally click the Browse button to select a differentĥ Select the serial port to use for the scan tool connection. Location window places the SPS application in theĭestination directory C:\Program Files\cosids. Note: Clicking the Next button on the Destination This displays the Choose Destination Location window.Ĥ Click the Next button.

This displays the Language Selection window.ģ Select a language for the application and then click the Next button.

If so, click the NO button to NOT reuseĢ Click the Next button to continue. Removed from the PC, a message may appear asking to Note: If the TIS2000 software was previous installed and The TIS 2000 Installation Welcome window appears automatically

GLOBALTIS ECU FILE LOCATION INSTALL

To install the SPS software, follow these steps:ġ Insert the Application CD into the PC’s CD drive.

GLOBALTIS ECU FILE LOCATION SOFTWARE

Step 2: Install the SPS Application CD software If your PC is already set up with TCP/IP protocol, go to To verify that TCP/IP protocol has been configured. If you have a network card installed then you only need Step 1: Determine if TCP/IP protocol is installed

An Application CD which loads the SPS application.

GM Service Programming System kit contains two compact discs (CD): All programming steps are activated and finalized through the PC The SPS application programs General Motors programmable control modules by using the Tech 2 Flash scan tool or the Next Generation scan tool as a “pass-thru” device to communicate program data to the vehicle control module. The GM Service Programming System (SPS) is a personal computer (PC) application used to reprogram vehicle electronic control modules (ECMs).